Install the rear crossmember.
Install the rear crossmember with the supplied 3/4" x 4.5" nuts, bolts, and washers. Do not tighten everything down yet. Leave them loose.
MENU / NAV / TOC
- HOME
- Toyota Tacoma
- Fabtech Suspension Lift Installation
- Pre-Installation Notes
- Front Installation
- Raise the Vehicle on Jackstands
- Remove the Factory Skid Plates
- Remove the Sway Bar
- Remove the Tie Rods
- Remove the Brake Calipers
- Remove the Brake Rotors
- Remove the Upper Ball Joints
- Remove the Shocks
- Remove the Steering Coupler
- Remove the Steering Rack
- Remove the Lower Control Arms
- Disconnect the Driveshaft
- Remove the Differential
- Cut out the Rear Crossmember
- Install the Rear Crossmember
- Install the Steering Coupler
- Install the Differential
- Install the Front Crossmember
- Install the Lower Control Arms
- Install the Steering Rack
- Attach the Steering Coupler to the Rack
- Dismantle and Rebuild the spring/shock assemblies
- Remove the Hubs
- Press the Bearings into the Knuckles (Pt. 1)
- Press the Bearings into the Knuckles (Pt. 2)
- Install the Upper Ball Joints
- Install the Steering Knuckles
- Modify the Front Brake Lines
- Install the Brake Line (and ABS) Brackets
- Flip the Power Steering Line Bracket
- Reposition the Power Steering Line Bracket
- Install the Sway Bar Drop Brackets
- Install the Differential Skid Plate
- Install the Impact Strut Mounts
- Install the Impact Struts
- Install the Wheel and Tires
- Rear Installation
- Fabtech Suspension Lift Installation
- Jeep Wrangler
Copyright © 2003-2008 Dorian Jepsen, dorianjepsen.com, dorianj.com. All rights reserved.
DorianJ.com is powered by MODx | 4x4 Parts
MySQL: 0.0037 s, 15 request(s), PHP: 0.0208 s, total: 0.0245 s, document retrieved from database.
Dorian Jepsen
DorianJ.com is powered by MODx | 4x4 Parts
MySQL: 0.0037 s, 15 request(s), PHP: 0.0208 s, total: 0.0245 s, document retrieved from database.
Dorian Jepsen
